Few systems are as vital to a home as its plumbing system. After all, what’s a modern household without water?
This is why, as a homeowner, it’s important to keep an eye on your plumbing system and act quickly in the event that something goes awry. Wondering what you should be keeping an eye out for? Then read on.
Here are some common household plumbing issues and how to fix them in Newnan, GA.
Slow Drainage
One of the most common plumbing problems to come across in a home is slow drainage. In other words, water won’t go down your drain at the speed that it typically does. This problem starts off mild and then grows worse over time, eventually resulting in standing water for hours upon hours.
How do you fix this problem? You have to clean your drain. If it’s only mildly dirty, you might be able to get the job done with a plastic drain snake.
However, if it’s taking hours for your water to fully evacuate into your drain, there’s no doubt that more intensive measures are needed. This is when it’s time to bring in a professional plumber. They’ll use a pro-grade snake to clear your drain of all residue, making it fully functional once again.
Common Plumbing Issues and How to Fix Them
You turn on your faucet . . . and water just barely trickles out. You turn on your shower . . . and water limply drips out of the showerhead. There’s no doubt about it: you’re experiencing low water pressure.
The question is: why? There are all sorts of reasons why your water pressure might be reduced. There could be a leak somewhere in your plumbing system; on the other hand, your main valve could have just been bumped accidentally.
There could also be an issue with your faucet itself. Plus, in some cases, it has nothing to do with the homeowner; the water company ends up being the one at fault.
Start by doing a bit of troubleshooting. If you can’t find the source of the issue, turn to a professional.
Constantly Running Toilet
Just about everyone has had this happen to them a time or two: you flush the toilet, only for it to never stop running. Water continues to stream into the toilet in perpetuity, resulting in a great deal of waste, not to mention that slightly grating sound.
What causes this to happen? An impaired flapper mechanism. This is the mechanism that seals the tank off from the bowl.
You might be able to fix it by randomly adjusting it. However, that’s not something you should bank on. In all likelihood, you’ll need to replace the flapper in its entirety.
For assistance with this, call your local plumber.
No Hot Water
Perhaps the most annoying plumbing problem is the problem of no hot water. When there’s no hot water available, you can’t properly shower, wash dishes, wash clothes, etc.
Of course, the problem lies in the water heater. The question is: what exactly is wrong with it?
In many cases, a water heater shuts down due to excess mineral buildup. In this case, it would simply need to be flushed.
In other cases, there’s an electricity or gas issue. In these cases, the wiring/piping would need to be checked by a professional.
There are also occasions when the water heater can’t keep up with the demand of the home. In these cases, you simply need to wait a bit. The water heater should produce hot water within a few minutes.
Water Leak
Water leaks can spring up from just about anything. You could have a leak from a pipe under your sink; you could have a leak from your showerhead; you could have a leak from your bathtub; you might even find a leak in your wall.
Regardless, it’s a plumbing emergency and something that needs to be responded to instantly. The fix is dependent on the specifics of the leak.
In some cases, you can get away with simply tightening a pipe. In other cases, you might have to replace a component entirely. If your bathtub is leaking, you’ll need to repair its seal.
Generally speaking, leaks require professional help. If you fail to tend to a leak in an appropriate manner, your home could incur substantial damage, the likes of which could cost you thousands of dollars worth of repairs.
Clogged Toilet
There are few things more mortifying than flushing a toilet and watching water quickly rise to the top of the bowl. Fortunately, in most cases, it stops before spilling over. Unfortunately, you still have a toilet to unclog.
The good thing is that generally speaking, you can unclog a toilet with nothing more than a plunger. Place the plunger fully under the water, suction it onto the hole within your toilet bowl, and then move it in an up-down motion 5 to 10 times.
With any luck, this will create a vacuum in the toilet, forcing all of the waste and water down through the hole. Alas, the problem will be averted.
But what if this doesn’t work? At that point, you’ll need to use a toilet snake or a liquid drain cleaner. If neither of these does the trick, you’ll just need to call up your local residential plumber.
Non-Functional Garbage Disposal
You hit the switch on your garbage disposal and . . . nothing. Well, you might hear a light buzzing sound, but it’s certainly not getting the job done.
This is a common issue in households the world over. Fortunately, it’s typically an easy fix. You can start by using your garbage disposal’s included tool to manually turn it from the bottom.
If this doesn’t work to get it going again, you’ll likely need to physically pull something from it. If that doesn’t do the trick, a part replacement is likely needed.
For Plumbing Repair in Newnan, GA Contact Progressive Heating, Air and Plumbing
Have you encountered any of the issues discussed above? Dealing with different plumbing issues in Newnan, GA? If so, and if you need the assistance of a certified Newnan plumber, look no further than Progressive Heating, Air Conditioning and Plumbing.
We’ve repaired countless problems with out expert plumbing services in Newnan. There’s no one better to call. So, contact us now to schedule plumbing repairs!
